SKU
SDS6

6mm ID Pressing Die Set w/ 2 Push Rods

Price $299.00
Wishlist

A set of 6mm diameter (ID) hardened steel dry pressing die set for pellet presses, ready for you to make 6mm diameter cylinder-shape pellets.


 

Die set includes

  • Three 6mm ID cylinder-shape core dies made of polished hardened steel
  • One steel sleeve
  • One steel support plate
  • Two push rods
  • One pellet ejector

Important

  • Always wear protection goggles during operation
  • Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
  • Never fill the die more than 1/3 its sleeve height with your sample and do not apply pressure beyond 4 tons. Across International is not responsible for any damage caused by misuse.
Specifications

Specifications

Maximum Pressure 4 tons
Rockwell Hardness Rc 62
Diameter (ID) 6 mm
Height 47 mm (assembled without sample)
Sleeve Height 25 mm
Sleeve Diameter (OD) 25 mm
Tolerance 0.01-0.02 mm (10-20 micron)
Max sample fill height Not to exceed 1/3 of the sleeve height
Material W18Cr4V hardened carbon tool steel

 

Overview

A set of 6mm diameter (ID) hardened steel dry pressing die set for pellet presses, ready for you to make 6mm diameter cylinder-shape pellets.


 

Die set includes

  • Three 6mm ID cylinder-shape core dies made of polished hardened steel
  • One steel sleeve
  • One steel support plate
  • Two push rods
  • One pellet ejector

Important

  • Always wear protection goggles during operation
  • Clean the die set throughout with absolute ethyl alcohol and keep them in a dry box with silica gel after use to avoid rusting on the surface.
  • Never fill the die more than 1/3 its sleeve height with your sample and do not apply pressure beyond 4 tons. Across International is not responsible for any damage caused by misuse.
Copyright © 2008-2023 Across International. All rights reserved.